Removal of Cu and Cr from chromated copper arsenate (CCA)-treated wood waste under batch electrodialytic conditions was studied. The effect of different types of extracting solutions, such as deionised water or aqueous solutions of NaCl, formic acid, oxalic acid, and EDTA, on the magnitude and direction of the fluxes of Cu- and Cr-containing species in the electrodialytic cell was investigated. Oxalic acid was found to have the best performance if simultaneous removal of the two elements is required (removal efficiencies of 80.5% for Cu and 87.4% for Cr, respectively). A mixture of oxalic acid and formic acid also led to similar removal efficiencies. In these experiments, the target elements were accumulated in both the anode and cathode compartments of the electrodialytic cell due to the formation of negatively charged complexes with the organic acids used besides the free cationic forms. The latter were not present if EDTA was the extracting solution resulting in directing the Cu and Cr fluxes to the anode compartment. Contrary, these fluxes were exclusively to the cathode compartment if deionised water or an aqueous solution of NaCl were used. These extracting solutions proved suitable for solubilising (re-mobilisation) of Cu but were less efficient for Cr removal (less than 20% removal). Overall, the results obtained show the important role of the proper selection of the type and composition of the extracting solution for the success of subsequent electrodialytic removal of Cu and Cr from CCA-treated wood waste.