Air-stable and thermal-stable lead telluride quantum dot was successfully prepared on glass substrate by inert gas condensation (IGC) method. Argon (Ar) is the inert gas used during deposition process with a constant flow rate of 3 × 10(-3)Torr. The effect of heat-treatment process at different times was studies for structure, optical and electrical properties for nanocrystalline thin films. The structures of the as deposited and heat-treated films were investigated using grazing incident in-plane X-ray diffraction (GIIXD). The GIIXD pattern showed nanostructure face centered cubic structure of PbTe thin films. The energy dispersive X-ray analysis (EDX) of as deposited PbTe thin film was carried out and showed that the atomic ratio of Pb/Te was 24/76. The particle size of the as deposited PbTe film and after stored it in an unhumid atmosphere are 6.8 ± 0.3 nm and 7.2 ± 0.3 nm respectively as estimated form TEM image (i.e. in the same level of particle size). However, the particle size was changed to be 11.8 ± 0.3 nm after heat-treated for 5h at 473K. These particle size values of PbTe thin film are smaller than its Bohr radius. The estimated value of optical band gap Eg decreased from 1.71 eV for the as deposited film to 1.62 eV for film heat-treated (5 h at 473K). The dc electrical conductivity is increased with raising temperature in the range (303-473K) for all thin films under investigation. The deduced activation energy decreased from 0.222 eV for as deposited sample to 0.125 eV after heat-treated at 473K for 5 h.
Keywords: Air-stable and thermal-stable lead telluride thin films; Electrical properties; Heat-treatment; Inert gas condensation; Nanostructure; Optical properties.
Crown Copyright © 2014. Published by Elsevier B.V. All rights reserved.