Results were obtained from contracting frog muscles by collecting high quality time-resolved, two-dimensional, X-ray diffraction patterns at the British Synchrotron Radiation Source (SERC, Daresbury, Laboratory). The structural transitions associated with isometric tension generation were recorded under conditions in which the three-dimensional order characteristic of the rest state is either present or absent. In both cases, new layer lines appear during tension generation, subsequent to changes from activation events in the thin filaments. Compared with the 'decorated' actin layer lines of the rigor state, the spacings of the new layer lines are similar whereas their intensities differ substantially. We conclude that in contracting muscle an actomyosin complex is formed whose structure is not like that in rigor, although it is possible that the interacting sites are the same. Transition from rest to plateau of tension is accompanied by approximately 1.6% increase in the axial spacing of the myosin layer lines. This is explained as arising from axial disposition of the interacting myosin heads in the actomyosin complex. Model calculations are presented which support this view. We argue that in a situation where an actomyosin complex is formed during contraction, one cannot describe the diffraction features as being either thick or thin filament based. Accordingly, the layer lines seen during tension generation are referred to as actomyosin layer lines. It is shown that these layer lines can be indexed as submultiples of a minimum axial repeat of approximately 218.7 nm. After lattice disorder effects are taken into account, the intensity increases on the 15th and 21st AM layer lines at spacings of approximately 14.58 and 10.4 nm respectively, show the same time course as tension rise. However, the time course of the intensity increase of the other actomyosin layer lines and of the spacing change (which is the same for both phenomena) shows a substantial lead over tension rise. These findings suggest that the actomyosin complex formed prior to tension rise is a non-tension-generating state and that this is followed by a transition of the complex to a tension-generating state. The intensity increase in the 15th actomyosin layer line, which parallels tension rise, can be accounted for assuming that in the tension-generating state the attached heads adopt (axially) a more perpendicular orientation with respect to the muscle axis than is seen at rest or in the non-tension-generating state. This suggests the existence of at least two structurally distinct interacting myosin head conformations.(ABSTRACT TRUNCATED AT 400 WORDS)